| 参数 | 价值 |
|---|---|
| Light grid | |
| 笔记 | G3 |
| 深度 | 113.6 mm |
| 震惊 | 10g for Δt = 16 ms (continuous shock, 1000 shocks in each space direction) |
| 宽度 | 45.2 mm |
| 高度 | 107.74 mm |
| 电压 | 24 V DC (via A1) |
| 可插拔 | yes |
| 接口 | DIN rail TBUS for connection to the master module, not supplied as standard |
| 欧姆负载 | min. 50 Ω (Observe limiting continuous current) |
| 应用 | Emergency stop |
| 指定 | A1/A2 |
| 过滤时间 | typ. 5 ms (at A1 in the event of voltage dips at Us) |
| 测试脉冲 | < 120 µs (Test pulse width of low test pulses) |
| 电缆长度 | max. 100 m (per input) |
| 产品类型 | Safety device |
| 重启时间 | min. 5 s (Boot time) |
| 安装类型 | DIN rail mounting |
| 响应时间 | see user manual |
| 停止类别 | 0 |
| 鉴别 | CE-compliant |
| 浪涌电流 | < 14.4 A (Δt = 0.5 ms at Us) |
| 状态显示 | 1 x LED (green), 1 x LED (orange), 1 x LED (blue) |
| 漏电流 | max. 500 µA |
| 错误指示 | 2 x LED (red) |
| 房屋材料 | Polyamide PA non-reinforced |
| 最大海拔 | ≤ 2000 m (Above sea level) |
| 输入数量 | 8 |
| 保护等级 | III |
| 剥皮长度 | 10 mm |
| 连接方式 | Push-in connection |
| 安装位置 | vertical or horizontal |
| 输出数量 | 4 |
| 输出描述 | Safety-related digital outputs |
| 保护电路 | Serial protection against polarity reversal |
| 传动速度 | 100 Mbps (Full duplex) |
| 当前消耗 | typ. 3.7 mA (typically with US) |
| 放电电路 | Yes, internal |
| 最大感性负载 | max. 2.4 mH |
| 开关频率 | max. 1/4 x tCycle[Hz] |
| 保护程度 | IP20 |
| 最大容性负载 | max. 820 nF |
| 组装说明 | Observe derating |
| 连接数 | 2 |
| 振动(操作) | 10 Hz ... 150 Hz, 2g |
| 通信协议 | PROFINET |
| 最大浪涌电流 | 1.1 A (Δt = 3 s at Us) |
| 正常运行模式 | 100% operating factor |
| 标称输出电压 | 24 V DC (Supply via A1) |
| 性能水平(PL) | e (2-channel wiring) |
| 美国电力消耗 | typ. 2.88 W (Outputs inactive) |
| 输入描述 | Safety-related digital inputs |
| 额定绝缘电压 | 250 V AC |
| 短路保护 | no |
| 工作电压显示 | 1 x green LED |
| 导线横截面 AWG | 24 ... 16 |
| 限制连续电流 | 400 mA (per channel) |
| 标称输出电压范围 | 18.5 V DC ... 28.1 V DC (US- 0,7 V) |
| 安全完整性等级 (SIL) | 3 |
| 导体横截面刚性 | 0.2 mm² ... 2.5 mm² |
| 输入电流范围“0”信号 | < 0.2 mA |
| 输入电压范围“0”信号 | 0 V DC ... 5 V DC |
| 输入电压范围“1”信号 | 11 V DC ... 28.8 V DC |
| 额定浪涌电压/绝缘 | Basic insulation 4 kV between all current paths and housing |
| 环境温度(运行) | -10 °C ... 70 °C (observe derating) |
| 额定控制电源电流 IS | 120 mA (RMS typ. inactive for all outputs) |
| 导体横截面可弯曲 | 0.2 mm² ... 2.5 mm² |
| 关闭时的输出电压 | < 0.3 V |
| 环境温度(储存/运输) | -20 °C ... 85 °C |
| 额定控制电路供电电压(美国) | 19.2 V DC ... 28.8 V DC |
| 机构场所的最低保护程度 | IP54 |
| 最大允许湿度(储存/运输) | 95 % (non-condensing) |
| 最大允许总导体电阻 | max. 1.2 kΩ (Input and reset circuit at US) |
| 最大允许相对湿度(运行) | 95 % (non-condensing) |
| 额定工况下的最大功率耗散 | 9.85 W (with max. permissible load) |
技术规格和性能数据
安装和操作指南