| 参数 | 价值 |
|---|---|
| 2, 3, 4-wire | |
| 笔记 | Notes on operation Line protection for the power cable, maximum 25 A. Observe derating of the POWER COMBICON connector |
| 深度 | 139 mm |
| 宽度 | 384 mm |
| 高度 | 182 mm |
| 数字 | 2 |
| 波纹 | Permissible ripple 3.6 Vppwithin the permissible voltage range |
| 输入名称 | Digital inputs |
| 净重 | 3136 g |
| 指定 | Terminal strip X13 |
| 过滤时间 | 3 ms |
| 输出名称 | Digital outputs |
| 输入电压 | 24 V DC (US1) |
| 安装类型 | Wall mounting |
| 输出电流 | max. 500 mA (per channel) |
| 供电电流 | typ. 0.25 A (at US1= 24 V; plus current of digital inputs/outputs) |
| 供电电压 | 24 V DC (US1/ US2) |
| 切换率 | 5 cycles per minute, maximum |
| 现场总线系统 | PROFINET |
| 频率范围 | 50 Hz ... 60 Hz (mains frequency) |
| 输入数量 | 10 |
| 参数化 | via PROFINET |
| 连接方式 | 8-pos. RJ45 socket on motor starter |
| 输出数量 | 4 |
| 工作电压 | 360 V AC ... 550 V AC (line voltage 50/60 Hz) |
| 钻孔间距 | 360 mm |
| 尺寸说明 | Module electronics without lower part |
| 保护类型 | Electronic short-circuit/overload protection, damping diode |
| 职位数量 | 8 |
| PG螺纹连接 | Pg11 |
| 保护程度 | IP67 in acc. with IEC 60529 |
| 供电电压范围 | 20 V DC ... 30 V DC (including ripple) |
| 利用类别 | On the basis of AC 3 |
| 标称电流范围 | 0.18 A ... 2.4 A |
| 参数化范围 | 0.2 A ... 2.4 A |
| 气压(运行) | 86 kPa ... 106 kPa (up to 2000 m above mean sea level) |
| 传感器电源 | UINI= US1minus 1 V 500 mA Short-circuit/overload protection |
| 指定连接点 | X30 and X31 |
| 关于重量规格的说明 | Module electronics without lower part |
| 输入电压范围“0”信号 | -3 V DC ... 5 V (binary "0") |
| 输入电压范围“1”信号 | 15 V DC ... 30 V DC (binary "1") |
| 最大载流能力 | 10 A |
| 环境温度(运行) | -25 °C ... 50 °C (non-condensing) |
| 气压(储存/运输) | 86 kPa ... 106 kPa (up to 2000 m above mean sea level) |
| 允许湿度(运行) | 0 % ... 85 % (non-condensing) |
| 每通道典型输入电流 | approx. 3 mA (for US1= 24 V) |
| 允许的导体横截面 | max. 0.14 mm² ... 0.22 mm² |
| 环境温度(储存/运输) | -25 °C ... 70 °C (non-condensing) |
| 允许湿度(储存/运输) | 75 % (slight temporary condensation may sometimes appear on the housing) |
| 额定电流下的最小输出电压 | US2minus 1 V |
技术规格和性能数据
安装和操作指南